How To Reset Edenpure Heater [Step-by-Step Instructions]

If you already own an EdenPure heater and want to know how to reset it, you have stepped on the right page. We will provide you with a step-by-step guide to reset your heater and make it work as new. 

What are EdenPure Heaters?

These space heaters are designed for a single room with a high-temperature safety switch. This switch cuts the unit off as soon as it reaches the preset max temperature. Apart from that, if you accidentally knock it over, the unit will automatically switch off. 

This is where you need to reset your heater. So, you have to disconnect it from the power source to reset its sensors. 

How to Reset EdenPure Heaters? 

Reset steps vary by model, so check your EdenPure heater’s owner’s manual first: EdenPure’s manual page links the model manuals, and current models have theirs on the product page. The steps below are the common method, and the times in them are typical rather than EdenPure’s own figures.

Here are the steps you need to take to reset your unit. 

Step 1

First, turn the power switch off or position it down to “0”. If you have tipped your unit over, you need to stand it upright. 

Step 2

Unplug its power cord from the electrical outlet. Now leave the heater unplugged for about half an hour. This will allow all those internal sensors to reset. 

Step 3 

The next step is to plug the power cord back into the electrical outlet. After that, turn the power switch on and adjust the temperature settings according to your requirements.

Troubleshooting Your EdenPure Heater

Here are some steps to follow if you are looking to troubleshoot your EdenPure Heater. 

Step 1

Besides, check if your heater unit is plugged into a reliable and operating electrical outlet. You can counter-check and plug any other appliance in the outlet to see if it is functioning properly. Make sure not to use any extension cables. These extensions can reduce the power that the heater unit receives, and CPSC advises plugging electric heaters directly into a wall outlet. 

Step 2 

Furthermore, you need to reset the unit’s thermostat if the room is not warm enough. You can turn it to its hottest setting and wait a few minutes for the internal fan to turn on. When the desired temperature is reached, bring down the thermostat.

Step 3 

Also, ensure you have cleaned the heater’s filter tray if you notice a drop in its performance. With a clogged filter, the heating output of the unit drops. Therefore, you must turn the heater off and look for its filter tray present in the back grille.

Now, slide the tabs up and get the filter out. Rinse it until the water runs clear, then let it air-dry completely before you put it back. Place the filter in the heater and continue the usage.

Step 4

If the room still feels cold, move the heater away from doors and windows. The heater works best in small spaces, so do not expect it to warm a large room.

Conclusion

Now you know how to reset the EdenPure heater and troubleshoot if it is not performing up to your standards. Make sure to keep its filter clean to improve its performance significantly.